P0671: Cylinder 1 glow plug circuit

P0671 on the Mercedes Sprinter VS30 falls under the glow plug / cold-start system fault group for the OM642 V6 diesel. The official Mercedes-Benz description is "Cylinder 1 glow plug circuit". The ECU sets this code when it detects an out-of-range condition in this system. Use the symptoms, common causes, and diagnostic steps below as a starting point, and always read the live data and freeze-frame for this specific code before replacing parts. If you're searching for the P0671 Mercedes Sprinter fix or P0671 VS30 / OM642 information, start with a full scan to capture any related codes stored at the same time.

• Cylinder 1 glow plug circuit

• Hard starting, especially in cold weather
• Rough running / misfire when cold
• Check engine light
• White smoke on cold start
• Glow plug warning indicator

• Failed glow plug(s)
• Faulty glow plug control module
• Wiring or connector fault to the glow system
• Low battery/system voltage affecting glow operation

1. 1Scan and record all codes, noting cylinder-specific glow faults.
2. 2Read live data for glow plug circuit status and module operation.
3. 3Test each glow plug's resistance and the control module's outputs.
4. 4Inspect wiring and connectors for corrosion or damage.
5. 5Replace the failed glow plug(s) or module, then clear codes and verify a clean cold start.

1. 1Replace the failed glow plug(s) — typically the cylinder(s) flagged.
2. 2Replace a faulty glow plug control module.
3. 3Repair corroded or damaged glow-system wiring and connectors.
4. 4Charge or replace a weak battery so glow voltage is adequate.