P0336: Crankshaft position sensor A range/performance

P0336 on the Mercedes Sprinter VS30 falls under the electrical / power supply / sensor circuit fault group for the OM642 V6 diesel. The official Mercedes-Benz description is "Crankshaft position sensor A range/performance". The ECU sets this code when it detects an out-of-range condition in this system. Use the symptoms, common causes, and diagnostic steps below as a starting point, and always read the live data and freeze-frame for this specific code before replacing parts. If you're searching for the P0336 Mercedes Sprinter fix or P0336 VS30 / OM642 information, start with a full scan to capture any related codes stored at the same time.

• Crankshaft position sensor A range/performance

• Check engine light
• Intermittent warning lights or electrical glitches
• Possible no-start or stalling
• Erratic gauge or sensor behavior
• Battery/charging warnings (on voltage faults)

• Corroded, loose, or damaged wiring/connector
• Failing sensor or actuator in the affected circuit
• Charging system fault (alternator) or weak battery
• Poor ground connection
• Water ingress into a connector

1. 1Scan and record all codes, noting any related circuit codes.
2. 2Inspect the affected circuit's wiring, connectors, and grounds for corrosion or damage.
3. 3Measure system/battery voltage and charging output for voltage-related codes.
4. 4Back-probe the circuit and compare live readings to spec.
5. 5Repair wiring/connector faults or replace the failed component.
6. 6Clear codes and verify the circuit operates correctly.

1. 1Repair corroded, loose, or damaged wiring and connectors.
2. 2Clean and tighten poor ground connections.
3. 3Replace the failed sensor or actuator in the affected circuit.
4. 4Replace a weak battery or repair the charging system for voltage faults.
5. 5Reseal connectors against water ingress.