Interfaz traducida. El contenido técnico sigue en inglés.

Diagnóstico / Códigos de avería

P059F

Cooling / Thermostat / Temperature Sensor Fault

Advertencia — revísalo prontoEngineOM642 V6 3.0L Diesel · VS30 / W907 (2019–Present)

P059F is a cooling / thermostat / temperature sensor fault on the Mercedes Sprinter VS30 (OM642 3.0L V6 diesel).

P059F on the Mercedes Sprinter VS30 falls under the cooling / thermostat / temperature sensor fault group for the OM642 V6 diesel. The ECU sets this code when it detects an out-of-range condition in this system. Use the symptoms, common causes, and diagnostic steps below as a starting point, and always read the live data and freeze-frame for this specific code before replacing parts. If you're searching for the P059F Mercedes Sprinter fix or P059F VS30 / OM642 information, start with a full scan to capture any related codes stored at the same time.

  • Engine running cold or overheating
  • Poor heater performance
  • Check engine light
  • Cooling fan running abnormally
  • Reduced fuel economy when running cold

Advertencia — revísalo pronto

P059F is a cooling / thermostat / temperature sensor fault on the Mercedes Sprinter VS30 (OM642 3.0L V6 diesel).

  • Stuck-open or stuck-closed thermostat
  • Faulty coolant temperature sensor
  • Low coolant level or air in the system
  • Wiring/connector fault to the sensor or thermostat heater
  • Failing water pump (in some cases)
  • Scan and record all codes; read freeze-frame for coolant temperature.
  • Compare the coolant temperature sensor's live reading to actual warm-up behavior.
  • Check coolant level and condition; bleed air if needed.
  • Test the thermostat operation (warm-up rate to operating temperature).
  • Inspect wiring/connectors to the sensor and map-controlled thermostat.
  • Replace the thermostat or sensor as indicated, then verify normal warm-up.
  • Replace a stuck thermostat (open or closed) and bleed the system.
  • Replace a faulty coolant-temperature sensor.
  • Top up coolant and purge air from the cooling system.
  • Repair wiring/connector faults to the sensor or map-controlled thermostat.
  • Replace a failing water pump if circulation is poor.